Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 06/26/2024 in all areas

  1. Hi All , I have just replaced both window winder motors in my 350Z track . On looking up all the available threads to do it , I noticed all the hassles owners have to overcome to get the window up for the repair . I was desperate , when mine jammed in the down position before I was ready to fix it , and still needed to use it . I started the motor , pulled the window switch up and banged the inside of the door panel roughly alongside where the motor is located . It jarred up the worn brushes for one last effort , and the window wound up much to my relief . I fastened two soft jaw Stanley clamps on the window to keep it from falling down again , while replacing the motor . One bit of advice I have noted on previous forums going forward , to avoid having to do the job again in the future . Is never to let the window go all the way to the bottom if you can help it , when using the window . It is a big heavy window , and needs a lot of leverage to move it resting at its lowest point . This is what prematurely wears the brushes out . That and try not to raise and lower the window with the motor off , this too stresses the brushes as the voltage is not as strong . Wish you luck , you can save a lot of money doing it yourself .
    1 point
  2. Glad you found (or at least your son did) the location. Usually Air Temp Sensors are in behind the front bumper area so not too far away from that then
    1 point
  3. Hey just introducing myself im Michael from Southampton i have traded my 2011 Qashqai ntec for a 2020 Qashqai tekna+. I am loving it but i am looking for a fuse cover for inside the glove box that isnt as expensive as they are on ebay if anyone can help?
    1 point
  4. hi thanks managed to reset and calibrate
    1 point
  5. Sounds like the Tire sensor has gone bad
    1 point
  6. Wonderful son managed to fix this to front xmember and attach wires! Air conditioning working nice and cold
    1 point
  7. Thanks for the welcome message. As to the models, I have always found them a better value proposition than the other Japanese makes, and that goes double for European cars. I have had other makes (briefly). Rover SD1 V8, Humber Imperial, Holden Commodores (my wife has had a series of wagons, up to her current 14 model SV6 wagon), and even an Aston Martin DB6 Vantage (for a couple of years). Thanks again, Phil
    1 point
  8. Purchased a ENV 200 and foxes are chewing the ABS cables. I payed over £400 to fix them and the next day they attacked the same cables is there a manufacture problem here never experienced this before. What is the best way to prevent this happening again if I have to shell out another payday for repairs
    0 points
  9. I purchased a Nissan Note 2021 recently and It is my first hybrid car. I noticed that out of the 4 battery points on the speedometer. Only, 2/4 battery points charges. I need to understand how Nissans battery system works and should I get the battery pack or the auxiliary battery checked?
    0 points
  10. ENGINE SWAP Can a QG 1.8L (silver top) engine be transferred from a manual N16 to an automatic? Do the crank bolts line up eg. manual flywheel v auto flex plate?
    0 points
×
×
  • Create New...